Motorcycle Headlight Colorful Tail Sticker 3-Layer Glossy Transparent Car Light Film

Color: Light Black, Dark Black, Light Blue, Dark Blue, Transparent, Purple, Orange, Green, Fluorescent Yellow, Red, Gold, Matte Black, Pink Name: Headlight Color Changing Film Grids: 0.3m*9m (if you need other grids, please contact customer service) Each piece is individually rolled, please place your order with confidence Tools used: Clean cloth, scraper, credit card, hairdryer 1. Clean the adhesive spots on the car body. If possible, use a lint-free cloth dipped in 50% alcohol or isopropyl alcohol or acetone for scrubbing. You can also use soapy water. Surfaces cleaned with solvent need to be allowed to completely evaporate before applying adhesive 2. Generally, slowly apply while using a tool to smooth it out and peel off the backing paper. 3. If the length and width of the car sticker are both less than 10cm cm, can all the stickers be peeled off and reapplied? 4. Use a clean cloth or scraper [such as a phone card or credit card] to repeatedly rub or scrape the film diagonally until there are no bubbles inside the car sticker, then peel off the [transparent] transfer film; it is recommended not to expose it to sunlight or wash the car within 24 hours. 【Wet Application Method】Car Stickers or Large Car Stickers Suitable [Recommended for Two Persons to Operate] 【Wet Application Steps】Tools Needed: Spray Bottle, Clean Cloth, Scraper, Utility Knife, Hair Dryer 1. Clean the surface to be pasted before preparing the sticker. Spray water evenly on the surface to be pasted (after cleaning the car body, use a spray bottle to spray water on the part of the car body to be pasted) - mainly used to reduce the sticker's adhesion and facilitate position adjustment. 2. After determining the position where you need to apply it, lift one side from right to left [or from top to bottom] along with the car sticker and press it onto the car surface with a cloth. Then apply it while using a cloth 3. When encountering door handles or anti-collision strips, cut and wrap or remove the material according to the situation. 4. Adjust in a timely manner, after confirming the general position of the graphic correctly, use a scraper to repeatedly remove water and air bubbles. When using the scraper, scrape diagonally from right to left. 5. Use a utility knife to evenly cut through the car doors and seams, and wrap them inward. 6. Try to let the moisture in the car sticker dry completely; if possible, use a hairdryer to moderately heat and dry it. Recommendation: Try not to expose it to direct sunlight within 24 hours, and it's not advisable to wash the car within 48 hours.