12V Start Scan Lighting Daytime Running Hood Strip Waterproof Car DIY Neon Through Light

Length Description: - Light source: LED - Light color: White/Ice Blue/Blue/Red - Voltage: 12V - Length: 150cm/180cm Features: - Newly designed car decorative light with start scan function - Side LEDs and corresponding hood designs can provide you with better lighting effects. - The length of the LED light strip can be DIY cut without damaging to fit all kinds of cars. Installation Tips: - How to install the light strip 1.Attach double-sided tape to both inner sides of the lampshade. 2. Secure the light strip on the double-sided tape. 3. Note: The cable arrangement should be close to the windshield side and not near the end of the central grille, otherwise it will affect the wiring and the normal opening of the hood. - How to connect the wires? 1. Connect the black wire to the negative terminal + red wire to ACC = the engine light starts to turn on. 2. Connect the black wire to the negative pole + red wire to DRL = turn on DRL to light up. 3. Connect the black wire to the negative pole + the red wire close to the light = turn on the low beam. 4. Connect the black wire to the negative pole + red wire to the high-brightness light = high-brightness light turns on. Notes: 1.Please allow 0.5-1.0inch differs due to manual measurement.( 1inch = 2.54cm ). 2.Due to different computer screens,the actual color may be slightly different from the product picture,thanks for your understanding 1.5M: 100g, 1.8M: 113g shipped in bags, each box +0.5